LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Secondary Engine Cooling System (Diesel)) >> Removal And Installation >> Degas Bottle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the powertrain secondary cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the air cleaner outlet pipe and the air cleaner cover. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Release the clamp and disconnect the EGR cooler-to-degas bottle hose from the degas bottle.
  4. Release the clamp and disconnect the Charge Air Cooler (CAC) and fuel cooler-to-degas bottle hose from the degas bottle.
  5. Release the clamp and disconnect the degas bottle-to-radiator hose from the degas bottle.
  6. Release the clamp and disconnect the degas bottle-to-coolant pump hose from the degas bottle.
  7. Remove the 2 degas bottle bolts and position the degas bottle to access the transmission fluid cooler-to-degas bottle hose.
    • To install, tighten to 7 Nm (62 lb-in).
  8. Squeeze the tabs to disconnect the transmission fluid cooler-to-degas bottle hose from the degas bottle and remove the degas bottle.
  9. To install, reverse the removal procedure.
  10. NOTE: Evaluate the cooling system condition before filling the cooling system. Failure to follow these instructions can damage the engine or cooling system.

    Evaluate the cooling system condition. For additional information, refer to COOLING SYSTEM CONDITION EVALUATION .

scientia non olet · About LEMON Manuals