LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Fuel Charging System & Fuel Control System - 6.7L) >> Removal And Installation >> Fuel Rail >> Installation

Fuel Rail: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

LH fuel rail 

  1. Install the LH fuel rail.
    • Hand start the 2 LH fuel rail bolts.
  2. Connect the 3 fuel charging wiring harness retainers to the LH fuel rail.
  3. Connect the fuel rail-to-fuel injection pump return tube fitting at the rear of the LH fuel rail.
  4. Connect the fuel rail pressure sensor electrical connector at the front of the LH fuel rail.
  5. Connect the fuel pressure control valve electrical connector at the rear of the LH fuel rail.
  6. Install the LH fuel injector supply tubes. For additional information, refer to FUEL INJECTOR SUPPLY TUBE .

    RH fuel rail 

  7. Install the RH fuel rail.
    • Hand start the 2 RH fuel rail bolts.
  8. Connect the 3 fuel charging wiring harness retainers to the RH fuel rail.
  9. Install the RH fuel injector supply tubes. For additional information, refer to FUEL INJECTOR SUPPLY TUBE .

    Both fuel rails 

  10. Install the fuel rail supply tube assembly. For additional information, refer to FUEL RAIL SUPPLY TUBE .
scientia non olet · About LEMON Manuals