Nitrogen Oxides (NOx) Modules
There are 2 NOx modules for the exhaust system. The nitrogen oxides bank 1, sensor 1 (NOx11) module is located on the right hand frame rail upstream of the selective catalytic reduction (SCR) catalyst. The nitrogen oxides bank 1, sensor 2 (NOx12) module is located on the right hand frame rail downstream of the SCR catalyst.
The NOx modules monitor the NOx sensors and control the NOx sensors heater element. The NOx modules communicate with the PCM through the controller area network (CAN) to report NOx concentrations, oxygen (O 2 ) concentrations, and NOx sensor system concerns.
The NOx module consists of a microprocessor, RAM, ROM, EEPROM, heater driver, and temperature sensor. The EEPROM stores the module calibration. The heater driver supplies a pulse width modulated (PWM) voltage to the heater portion of the sensor to maintain operational temperature. The microprocessor processes all of the inputs from the sensor and communicates the information to the PCM. The temperature sensor in the module is used for compensating the temperature dependency of circuit components and for NOx module and NOx sensor rationality checks.