LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Wiper System & Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl top vent panels. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 3 wiper mounting arm and pivot shaft bolts.
    • To install, tighten to 8 Nm (71 lb-in).
  3. Disconnect the wiper motor electrical connector.
  4. Remove the wiper mounting arm and pivot shaft assembly.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals