LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Steering Column) >> Removal And Installation >> Steering Wheel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Turn the steering wheel to the straight-ahead position.
  3. Remove and discard the steering wheel bolt.
    • To install, tighten the new bolt to 48 Nm (35 lb-ft).
  4. Remove the steering wheel while routing the wires from the clockspring through the steering wheel.
  5. Tape the clockspring center rotor to the outer housing to keep it from rotating.
    Fig 1: Locating Outer Housing Center Rotor
    G06063996Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals