LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Steering Column) >> General Procedures >> Steering Wheel Wrap Bonding

Steering Wheel Wrap Bonding

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL

Item Specification
Instant Gel Adhesive
TA-19		 WSK-M2G402-A4
  1. NOTE: If re-adhering leather to the front side of the steering wheel only, it will not be necessary to remove the steering wheel. Steering wheel removal is necessary only when repairing loose leather on the backside of the steering wheel.

    If necessary remove the steering wheel. For additional information, refer to STEERING WHEEL .

  2. Position the loose leather out of the way.
  3. Apply the specified adhesive evenly over the wheel spoke.
  4. Position the loose leather back into the original position.
  5. NOTE: The adhesive should be completely set after 5 minutes. Do not pull on the repair area.

    Smooth the leather and tuck in for neat appearance.

    • Apply pressure (for at least 30 seconds) until the leather is bonded to the wheel spoke.
  6. If removed, Install the steering wheel. For additional information, refer to STEERING WHEEL .
scientia non olet · About LEMON Manuals