LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System (Diesel)) >> Removal And Installation >> Cooling Fan Shroud - Upper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet tube and the air cleaner cover. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Remove the 2 bolts and position the secondary cooling system degas bottle aside.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Detach the secondary radiator-to-EGR cooler hose retainer from the upper fan shroud.
  4. Detach the 2 horn wiring harness retainers from the upper fan shroud.
  5. Detach the primary radiator overflow hose retainer and position the primary radiator overflow hose aside.
  6. Remove the bolt and position the power steering fluid reservoir aside.
    • To install, tighten to 7 Nm (62 lb-in).
  7. Detach the 2 Charge Air Cooler Temperature (CACT) sensor wiring harness retainers and position the CACT sensor wiring harness aside.
  8. Detach the fuel cooler-to-degas bottle hose retainer and position the fuel cooler-to-degas bottle hose aside.
  9. Remove the 5 bolts and the upper cooling fan shroud.
    • To install, tighten to 7 Nm (62 lb-in).
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals