LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Engine Cooling System (Gas)) >> Removal And Installation >> Cooling Fan Shroud - 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the cooling fan. For additional information, refer to COOLING FAN - 6.8L .
  3. Detach the 5 wiring harness retainers from the cooling fan shroud.
  4. Detach the front impact severity sensor wiring harness retainer from the cooling fan shroud.
  5. Remove the 4 cooling fan shroud bolts.
    • To install, tighten to 7 Nm (62 lb-in).
  6. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  7. Remove the bolt and position the power steering reservoir aside.
    • To install, tighten to 7 Nm (62 lb-in).
  8. Detach the radiator-to-degas bottle hose retainer from the cooling fan shroud.
  9. Disconnect the Electronic Shift-On-The-Fly (ESOF) solenoid electrical connector from the blank.
  10. Detach the 6 wiring harness retainers from the RH side of the cooling fan shroud.
  11. Remove the cooling fan shroud.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals