Instrument Panel Finish Panel - Center, Lower

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

If equipped, remove the floor console. For additional information, refer to CONSOLE - FLOOR .
Remove the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL FINISH PANEL - CENTER, UPPER .
Remove the steering column opening trim panel.
- Pull rearward on the bottom edge.
  
  Fig 1: Locating Steering Column Opening Trim Panel
  Courtesy of FORD MOTOR CO.
Remove the lower instrument panel center finish panel screw.

Fig 2: Locating Lower Instrument Panel Center Finish Panel Screw
Courtesy of FORD MOTOR CO.
Remove the 2 lower instrument panel center finish panel screws.

Fig 3: Locating Lower Instrument Panel Center Finish Panel Screws
Courtesy of FORD MOTOR CO.

Vehicles equipped with an automatic transmission
Open the cup holder.

Fig 4: Locating Cup Holder
Courtesy of FORD MOTOR CO.
Remove the 2 cup holder screws.

Fig 5: Locating Cup Holder Screws
Courtesy of FORD MOTOR CO.

All vehicles
Remove the lower instrument panel center finish panel.
To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.