LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Instrument Panel And Console) >> Removal And Installation >> Console - Overhead >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the rear edge of the overhead console downward, at the locations shown below, and then pull rearward.
    Fig 1: Pulling Rear Edge Of Overhead Console Downward
    G06462852Courtesy of FORD MOTOR CO.
  2. Disconnect the electrical connectors.
  3. Remove the overhead console.
  4. To install, reverse the removal procedure.
    • Make sure to align the overhead console retaining clips to the adjacent clip holes.
scientia non olet · About LEMON Manuals