LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the water shield aside.
  3. Disconnect the keyless entry keypad electrical connector.
  4. Remove the retaining clip and the keyless entry keypad and harness.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals