LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Autolock and Auto-Unlock Programming >> Programming the Autolock Feature Using the Keyless Entry Keypad

Programming the Autolock Feature Using the Keyless Entry Keypad

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The autolock feature can also be programmed using the message center.
NOTE: The autolock feature can be activated or deactivated independently of the auto-unlock feature.
  1. Turn the ignition key to the OFF position and close all vehicle doors.
  2. Enter the permanent factory keyless entry keypad code.
  3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.
  4. Release the 7/8 button, then release the 3/4 button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a honk) if the autolocks are enabled.
scientia non olet · About LEMON Manuals