LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Autolock and Auto-Unlock Programming >> Programming the Auto-Unlock Feature Using the Keyless Entry Keypad

Programming the Auto-Unlock Feature Using the Keyless Entry Keypad

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The auto-unlock feature can also be programmed using the message center.
NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.
  1. Turn the ignition key to the OFF position and close all vehicle doors.
  2. Enter the permanent factory keyless entry keypad code.
  3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release the 7/8 button a second time.
  4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
scientia non olet · About LEMON Manuals