Seat - Front, Bucket Seat: Installation

All seats 

1. Install the seat retainers in the following sequence.
   1. Install a new front inboard seat track-to-floor bolt.
      • Tighten to 70 Nm (52 lb-ft).
   2. Install a new front outboard seat track-to-floor bolt.
      • Tighten to 70 Nm (52 lb-ft).
   3. Install a new rear inboard seat track-to-floor bolt.
      • Tighten to 70 Nm (52 lb-ft).
   4. Install the rear outboard seat track-to-floor nut.
      • Tighten to 70 Nm (52 lb-ft).

   Seats with side air bags 

2. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .

   Driver seat without side air bags 

3. Prove out the RCM as follows:

   Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF. If an air bag SRS fault is present, the air bag warning indicator will:

   • fail to light.
   • remain lit continuously.
   • flash at a 5 Hz rate (RCM not configured).

   The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.

   Clear all continuous memory DTCs from the RCM using a scan tool.