LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Anti-Lock Brake System & Stability Control) >> Diagnosis And Testing >> Anti-Lock Control - Four-Channel >> Pinpoint Tests >> Pinpoint Test AC: DTC U0151:00 >> Pinpoint Test Ac: DTC U0151:00

Pinpoint Test Ac: DTC U0151:00

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. AC1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    1. Yes  : GO to AC2.
    2. No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AC2 CHECK THE COMMUNICATION NETWORK 
    • Connect the scan tool.
    • Using a scan tool, carry out the Network Test.
    • Does the RCM pass the Network Test? 
    1. Yes  : GO to AC3.
    2. No  : REFER to MODULE COMMUNICATIONS NETWORK .
  3. AC3 RETRIEVE THE RECORDED DTCs FROM THE ABS MODULE AND RCM MODULE SELF-TESTS 
    • Enter the following diagnostic mode on the scan tool: Self Test - ABS Module.
    • Enter the following diagnostic mode on the scan tool: Self Test - RCM.
    • Is DTC B11E8:16 (U3003:16) or DTC B11E8:17 (U3003:17) recorded? 
    1. Yes  : For ABS module DTC B11E8:16, GO to PINPOINT TEST P .

      For ABS module DTC B11E8:17, GO to PINPOINT TEST Q .

      For the RCM, REFER to SUPPLEMENTAL RESTRAINT SYSTEM .

    2. No  : GO to AC4.
  4. AC4 RECHECK THE ABS MODULE DTCs 
    • Using a scan tool, clear the ABS module DTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Enter the following diagnostic mode on the scan tool: Self Test - ABS Module.
    • Is DTC U0151:00 still present? 
    1. Yes  : GO to AC5.
    2. No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  5. AC5 CHECK FOR DTC U0151:00 SET IN OTHER MODULES 
    • Using a scan tool, clear all CMDTCs.
    • Ignition OFF.
    • Ignition ON.
    • Wait 10 seconds.
    • Enter the following diagnostic mode on the scan tool: Self Test - All CMDTCs.
    • Retrieve the continuous memory DTCs from all modules.
    • Is DTC U0151:00 set in more than one module? 
    1. Yes  : INSTALL a new RCM. REFER to SUPPLEMENTAL RESTRAINT SYSTEM . CLEAR the DTCs. REPEAT the ABS module self-test.
    2. No  : INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . TEST the system for normal operation.
scientia non olet · About LEMON Manuals