LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Hydraulic Brake System Actuation) >> General Procedures >> Adjustable Pedal Indexing

Adjustable Pedal Indexing

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The adjustable pedal system must be indexed whenever the brake pedal assembly or accelerator pedal assembly is installed or damage to the components may result.
  1. NOTE: Make sure the electrical connector is connected to the adjustable pedal motor.

    Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal drive.

    Fig 1: Locating Adjustable Brake Pedal Drive Cable
    G06762756Courtesy of FORD MOTOR CO.
  2. Operate the accelerator pedal to the full rearward position.
  3. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  4. Operate the adjustable pedals to the full forward position.
  5. Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal assembly.
  6. Operate the adjustable accelerator pedal to the full forward position.
  7. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  8. Check that the brake and accelerator pedals can be fully adjusted forward and rearward.
scientia non olet · About LEMON Manuals