Section 54 (Rear Drive Axle/Differential (DANA S110/S130)): Specifications

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

MATERIAL SPECIFICATION

Item

Specification

Fill Capacity

Gasket Maker TA-16

WSK-M2G348-A5

Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant
XY-75W140-QL (US); CXY-75W140-1L (Canada)

WSL-M2C192-A and GL-5

6.6L (14 pt) ⁽¹⁾

Threadlock 262
TA-26

WSK-M2G351-A6

⁽¹⁾	The lubricant capacity will vary depending upon the housing mounting angle. The capacity given is for an angle of 4 degrees. A lubricant level close enough to the bottom of the fill hole to be seen or touched is not sufficient. The lubricant must be level with the fill hole.

GENERAL SPECIFICATIONS

Item

Specification

Pinion bearing preload ⁽¹⁾

2.3-4.5 Nm (20-40 lb-in)

Differential ring gear to pinion backlash ⁽¹⁾

0.23-0.41 mm (0.009-0.016 in)

⁽¹⁾	Establish the pinion bearing preload prior to pinion seal installation.

⁽²⁾

The acceptable backlash tolerance is ± 0.0508 mm (0.002 in) from the backlash etched in the differential ring gear. The tooth contact pattern can move only by adjusting backlash. The tooth contact pattern can move only in the direction of heel-to-toe and toe-to-heel. Depth of the tooth contact pattern is not adjustable. Contact Spicer Service at 1-800-826-4357 for assistance if unable to establish an acceptable tooth contact pattern within the limits of backlash.

TORQUE SPECIFICATIONS

Description

lb-ft

lb-in

Brake tube-to-flexible hose fitting

159

Differential bearing cap bolt

190

140

Differential carrier housing bolt ⁽²⁾

Driveshaft bolts (vehicles with circular flange)

100

Driveshaft bolts (vehicles with split pin yoke)

Fill plug

Pinion hex nut

1128

832

Rear wheel speed sensor bolt

177

Ring gear bolts⁽¹⁾

203

150

Shock absorber nuts and bolts

U-bolt nuts⁽²⁾

⁽¹⁾	Manufacturer recommends installing NEW ring gear bolts during reassembly.

⁽²⁾	Refer to the procedure in this article.