LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Steering Column Switches) >> Removal And Installation >> Circuit Deactivation Ignition Module (CDIM) >> Installation

Circuit Deactivation Ignition Module (CDIM): Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector.
  2. Position the CDIM and install the 2 pin-type retainers.
    • If the CDIM is being installed new as a dealership option, the PCM must be enabled. For additional information, refer to the Extended Idle Shutdown Initialization General Procedure in ELECTRONIC ENGINE CONTROLS - DIESEL ENGINES .
scientia non olet · About LEMON Manuals