LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Front Suspension (RWD)) >> Removal And Installation >> Axle - F-250, F-350 >> Installation

Axle - F-250, F-350: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the pivot bushing for wear or damage. Install a new bushing as necessary.
  2. NOTE: Tighten the axle pivot nut with the suspension at curb height or damage to the bushing may occur.

    Position the front axle into the pivot bracket, install the new pivot bolt and nut until snug.

  3. Install the radius arm. For additional information, refer to RADIUS ARM - F-250, F-350 .
  4. Install the wheel spindle. For additional information, refer to WHEEL SPINDLE - F-250, F-350 .
  5. With the vehicle at curb height, tighten the new axle pivot nut to 175 Nm (129 lb-ft).
  6. Check and, if necessary, align the front end. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals