Exhaust Downpipe - 6.7L Diesel: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Discard the exhaust upper downpipe clamp after removal. Install new during assembly.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the 2 bracket bolts and position the transmission fluid filler tubes aside.

Fig 1: Locating Transmission Fluid Filler Tubes Bracket Bolts
Courtesy of FORD MOTOR CO.
Remove the crankcase vent oil separator. For additional information, refer to ENGINE EMISSION CONTROL .
NOTE: Note the position of the exhaust upper downpipe clamp for installation.

Loosen the exhaust upper downpipe clamp.
Remove the RH fender splash shield. For additional information, refer to FRONT END BODY PANELS .
Remove the exhaust upper downpipe bracket bolt.

Fig 2: Locating Exhaust Upper Downpipe Bracket Bolt
Courtesy of FORD MOTOR CO.
Remove the 2 exhaust lower downpipe-to-catalyst and particulate filter assembly bolts.
- Remove the downpipe assembly and discard the exhaust upper downpipe clamp.
  
  Fig 3: Locating Exhaust Lower Downpipe-To-Catalyst And Particulate Filter Assembly Bolts
  Courtesy of FORD MOTOR CO.
NOTE: Mark the exhaust upper and lower downpipes and Torca® clamp for orientation during installation.

If necessary, loosen the Torca® clamp and separate the exhaust upper and lower downpipes.

Fig 4: Locating Exhaust Upper And Lower Downpipes And Torca® Clamp Orientation Mark
Courtesy of FORD MOTOR CO.