LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Wheels & Tires) >> General Procedures >> Wheel and Tire - Single Rear Wheel (SRW) >> Removal

Wheel and Tire - Single Rear Wheel (SRW): Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, remove the wheel cover.
  2. Check the torque for all of the wheel nuts. If any wheel nuts have a torque above 312 Nm (230 lb-ft), install all new wheel studs on that wheel hub. For additional information, Refer to the appropriate Suspension article for the procedure.
  3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  4. NOTE: Do not use heat to loosen a seized wheel nut or damage to the wheel and wheel bearing an occur.

    Remove the wheel nuts and the wheel and tire assembly.

scientia non olet · About LEMON Manuals