Removal And Installation: Seat: Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the LH and RH quarter trim panels. REFER to QUARTER TRIM PANEL - WITHOUT INFLATABLE SAFETY BELTS or REFER to QUARTER TRIM PANEL - WITH INFLATABLE SAFETY BELTS .
- Connect the third row power fold seat control switch, if equipped.
-
NOTE: If equipped with inoperative power seat, Refer to MANUAL OVERRIDE OF INOPERATIVE POWER SEAT - 3RD ROW .
Position both seats to the load floor position.
-
NOTE: If equipped with a power seat, do not lift the load floor flapper panels too far or damage to the wire harness retainers will occur.
Separate the 2 load floor supports (1 shown in illustration).
- Push the load floor support rearward and slightly lift the load floor to disengage.
- If equipped, disconnect the electrical connector and detach the wire harness retainers.
- Detach the 2 wire harness retainers on the RH side.
- Remove the 4 mounting bracket-to-floor bolts and remove the third row seat.