Removal And Installation: Seat: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the third row seat and the 4 mounting bracket-to-floor bolts.
- Tighten to 80 Nm (59 lb-ft).
- If equipped, connect the electrical connector and attach the wire harness retainers.
- Attach the 2 load floor supports.
- If equipped, disconnect the third row power fold seat control switch.
- Install the LH and RH quarter trim panels. REFER to QUARTER TRIM PANEL - WITHOUT INFLATABLE SAFETY BELTS or REFER to QUARTER TRIM PANEL - WITH INFLATABLE SAFETY BELTS .