Seat Cushion Cover - Manual: Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For component identification and locations, Refer to SEAT - EXPLODED VIEW .
- Remove the 2 screw and pull the cushion handle out of the pocket.
- Separate the pivot release cable and casing and remove the pivot release handle.
- Remove the 2 screws on each side at the bottom of the load floor panel.
- Pull out to release the retainers and remove the load floor panel.
- Use a suitable tool to disengage the load floor from the seat.
- Remove the screw, release the tab and remove the floor latch cover.
- Release the cushion trim cover retainers from the cushion frame.
- Detach and remove the cushion cover.