Power-Fold Seat Module (PFSM): Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
On the first press of the seat control switch after the seat is repaired and a new system component has been installed, the PFSM
moves the seat to the home position (seat folded and latched to the floor) before continuing to move to the selected seat position. This allows the PFSM
to relearn the position of the affected motors.
- Carefully lift the LH load floor flapper panel, install the PFSM , connect the electrical connectors and attach the retainers.
- Slightly raise the LH load floor flapper panel, attach the wire harness retainer to the load floor support studs.
- Attach the LH load floor support to the load floor panel.