LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 312 (Seat System - Seats-Seating - 3RD Row) >> General Procedures >> Manual Override of Inoperative Power Seat - 3rd Row >> To Release an Inoperable Seat Latch

To Release an Inoperable Seat Latch

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: RH seat shown in illustration, LH similar.
  1. Push the cushion cover and foam pad back and locate the power seat latch by-pass cut-out in the bracket.
    Fig 1: Locating Power Seat Latch By-Pass Cut-Out
    G06285801Courtesy of FORD MOTOR CO.
  2. Slide a screwdriver through the latch bracket until it bottoms out on the latch mechanism. Make sure the screwdriver is straight up and down and not on an angle or the screwdriver will not come in contact with the latch release lever.
    Fig 2: Sliding Screwdriver Through Latch Bracket
    G06285802Courtesy of FORD MOTOR CO.
  3. Pivot the screwdriver handle toward the front of the seat, releasing the latch.
Fig 3: Releasing Latch Using Screwdriver
G06285803Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals