LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Body Panel System - Body Closures) >> Removal And Installation >> Liftgate >> Removal

Removal And Installation: Liftgate: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Manual liftgate shown, power liftgate similar.
  1. Remove the bolt at the liftgate and position the ground strap aside.
    G07429129
  2. Position aside the liftgate opening weatherstrip.
  3. Remove the liftgate trim panel. REFER to LIFTGATE TRIM PANEL .
  4. Disconnect the center high-mount stop lamp electrical connector.
    G07429130
  5. NOTE: LH side shown, RH side similar.

    Disconnect the heated backlight electrical connectors.

    G07429131
  6. Disconnect the rear wiper motor electrical connector.
    G07429132
  7. Disconnect the license lamp electrical connector.
    G07429133
  8. Disconnect the liftgate latch electrical connectors.
    G07429134
  9. G07429135
  10. Remove the wiring harness pushpin retainers.
  11. Remove the wiring harness boot at the liftgate opening and route the wiring harness out of the liftgate.
    G07429142
  12. Remove the rear washer hose boot at the body and disconnect the washer hose.
    G07429137
  13. NOTE: LH side shown, RH side similar.

    Loosen but do not remove the liftgate-to-hinge bolts.

    G07429138
  14. Manually support the liftgate.
  15. NOTE: LH side shown, RH side similar.

    Disconnect the liftgate supports at the liftgate.

    G07429139
  16. With the help of an assistant, remove the liftgate-to-hinge bolts and remove the liftgate.
scientia non olet · About LEMON Manuals