LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 309 (Safety Belt System) >> Removal And Installation >> Safety Belt Shoulder Height Adjuster >> Removal

Safety Belt Shoulder Height Adjuster: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision, refer to Safety Belt Inspection and Repair After a Collision  . Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.
  1. Remove the B-pillar trim panels. REFER to B-PILLAR TRIM PANEL .
  2. Remove the bolt and the D-ring.
  3. Remove the safety belt shoulder height adjuster in the following sequence.
    1. Remove the safety belt shoulder height adjuster bolt.
    2. Rotate the top of the safety belt shoulder height adjuster down 90.
    3. Turn the bottom of the safety belt shoulder height adjuster, disengaging the T-tab from the B-pillar sheet metal and remove the safety belt shoulder height adjuster.
scientia non olet · About LEMON Manuals