Window Glass - Rear: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Remove rear wiper motor. REFER to WIPER MOTOR - REAR WINDOW .
Remove the liftgate spoiler. REFER to SPOILER .
Disconnect the 2 liftgate window defrost electrical connectors.
WARNING: Wear eye and ear protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.

WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.

NOTE: To avoid rust formation, use extreme care not to scratch the paint or primer, or otherwise damage the pinch weld during glass removal.

NOTE: Lubricate the existing urethane adhesive with water to aid the 300-AST1770E while cutting.

NOTE: Insert the blade into the 300-AST1770E so that the flat side is against the glass. This will leave the entire urethane adhesive bead on the pinch weld and allow a dry fit of the replacement rear glass.

Using the 300-AST1770E, begin cutting the urethane adhesive at the top center and work toward the bottom corners.
Using the 300-AST1770E, cut the remaining urethane adhesive and remove the rear window glass.