Transmission Fluid Cooler Tubes - 3.7L Ti-VCT With Auxiliary Transmission Fluid Cooler: Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
-
- Tighten to 9 Nm (80 lb-in).
-
- Tighten to 6 Nm (53 lb-in).
-
- Tighten to 70 Nm (52 lb-ft).
- Install the front bumper cover. REFER to INSTALLATION .
-
- Seal 7D258
- Backing ring 7J324
- Tighten to 30 Nm (22 lb-ft).
- Visual check. Apply the specified lubricant to the specified component.
- Material: Motorcraft® MERCON® LV Automatic Transmission Fluid.
-
- Tighten to 11 Nm (97 lb-in).
- Install the ACL assembly. REFER to INTAKE AIR SYSTEM COMPONENTS - EXPLODED VIEW .
- Check the Motorcraft® MERCON® LV Automatic Transmission Fluid level and add Motorcraft® MERCON® LV Automatic Transmission Fluid as necessary.