LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 286 (Handles, Locks, Latches And Entry Systems - Without Intelligent Access) >> Removal And Installation >> Hood Latch Release Handle >> Removal

Hood Latch Release Handle: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. REFER to BATTERY AND BATTERY TRAY - EXPLODED VIEW .
  2. Remove the hood latch. Refer to HOOD LATCH .
  3. Remove the 2 bolts and remove the steering column cover trim panel.
    • Pull outward to release the retainers.
    • To install, tighten to 3 Nm (27 lb-in).
      G07430978
  4. Remove the body control module. REFER to BODY CONTROL MODULE (BCM) - WITHOUT INTELLIGENT ACCESS .
  5. Remove the 3 BCM-B  bracket nuts and position aside the bracket.
    • To install, tighten to 9 Nm (80 lb-in).
  6. Release the hood latch release cable routing clips.
  7. Remove the hood release handle screw and remove the hood release handle.
    • To install, tighten to 2.2 Nm (19 lb-in).
      G07429284
  8. Remove hood latch release handle and cable.
    • Pull the hood latch release handle and cable through the cowl panel into the interior.
scientia non olet · About LEMON Manuals