LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Fuel Tank & Fuel Lines) >> Removal And Installation >> Fuel Tank - Midship >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  3. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Drain the fuel from the fuel tank. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .

    Gasoline engines 

  5. Loosen the hose clamp and disconnect the fuel tank filler pipe from the fuel tank.
  6. Disconnect the fuel tank filler pipe vent tube quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .

    Diesel engine 

  7. Loosen the 2 hose clamps and disconnect the fuel tank filler pipe and fuel tank filler pipe vent tube from the fuel tank.

    All vehicles 

  8. Place a jack under the fuel tank.
  9. NOTE: The 142 L (37.5 gal) midship fuel tank has 3 fuel tank straps and 6 cradle bracket bolts. All other midship fuel tanks have 2 fuel tank straps and 4 cradle bracket bolts.

    Remove the 4 or 6 fuel tank strap bolts and remove the 2 or 3 fuel tank straps.

    • To install, tighten to 40 Nm (30 lb-ft).
  10. Partially lower the fuel tank for access.

    Gasoline engines 

  11. Disconnect the fuel vapor tube-to-Fuel Pump (FP) module quick connect coupling and the fuel supply tube-to-FP module quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  12. Disconnect the fuel vapor tube-to-fuel tank grade vent valve quick connect couplings. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  13. Disconnect the FP module electrical connector.

    Diesel engine 

  14. Disconnect the fuel return tube-to-fuel level sensor quick connect coupling and the fuel supply tube-to-fuel level sensor quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  15. Disconnect the fuel level sensor electrical connector.

    All vehicles 

  16. Lower the fuel tank.
  17. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals