LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Fuel Tank & Fuel Lines) >> Disassembly And Assembly >> Fuel Conditioning Module - 6.7L Diesel >> Assembly

Fuel Conditioning Module - 6.7L Diesel: Assembly

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel conditioning module housing, the 2 spacers and the 2 bolts.
    • Tighten to 5 Nm (44 lb-in).
  2. Lubricate the new O-ring seal with clean engine oil and install the new fuel filter.
  3. Install the O-ring seal on the fuel conditioning module housing and lubricate with clean engine oil.
  4. Install the filter cover.
    • Tighten the filter cover until it contacts the mechanical stops.
  5. Lubricate the O-ring seal with clean engine oil and install the water-in-fuel sensor.
    • Tighten to 5 Nm (44 lb-in).
  6. Lubricate the O-ring seal with clean engine oil and install the drain plug hand tight.
scientia non olet · About LEMON Manuals