LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 278 (Body Panel System - Front End Body Panels) >> General Procedures >> Hood Alignment >> General Procedure

General Procedure

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the LH and RH rear hinge-to-hood bolts to the point that the hood will have slight movement.
  2. Loosen the LH and RH front hinge-to-hood bolts to the point that the hood will have slight movement.
  3. Adjust the hood to specification. REFER to BODY REPAIRS , Component Description.
  4. Carefully open the hood and tighten the LH and RH front and rear hinge-to-hood bolts.
    • Tighten to 12 Nm (106 lb-in).
  5. NOTE: The hood adjusting bumpers are located in the hood panel.

    Adjust the hood bumpers so the hood fits flush to the fenders.

scientia non olet · About LEMON Manuals