LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Seat System - Seats-Seating - 2ND Row) >> Removal And Installation >> Seat >> Removal

Removal And Installation: Seat: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with inflatable safety belts, depower the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITH INTELLIGENT ACCESS or REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITHOUT INTELLIGENT ACCESS .
  2. NOTE: Returning the seat from the E-Z entry position to the load floor position will latch the inboard latch foot.
    The inboard latch foot must latch before the seat backrest will return to the upright position.
    Returning the seat backrest to the upright position will latch the outboard latch foot.

    Using the recliner handle, fold the affected seat up to the E-Z entry position.

  3. If equipped, disconnect the seat electrical connector(s).
  4. Remove the 2 seat-to-floor bolts and 2 seat-to-floor nuts for the affected seat.
  5. Remove the seat.
scientia non olet · About LEMON Manuals