Removal And Installation: Seat: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

For the RH 40 percent seat, position the seat in the vehicle and install the retainers.
1. Install the seat-to-floor rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
2. Install the seat-to-floor rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
3. Install the seat-to-floor front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
4. Install the seat-to-floor front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
    
    Fig 1: Locating Seat-To-Floor Inboard Bolt Tightening Sequence (For RH 40 Percent Seat)
    Courtesy of FORD MOTOR CO.
For the 60 percent seat or LH 40 percent seat, position the seat in the vehicle and install the retainers.
1. Install the seat-to-floor rear inboard nut.
  - Tighten to 48 Nm (35 lb-ft).
2. Install the seat-to-floor rear outboard nut.
  - Tighten to 48 Nm (35 lb-ft).
3. Install the seat-to-floor front outboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
4. Install the seat-to-floor front inboard bolt.
  - Tighten to 48 Nm (35 lb-ft).
    
    Fig 2: Locating Seat-To-Floor Inboard Bolt Tightening Sequence (For LH 40 Percent Seat)
    Courtesy of FORD MOTOR CO.
Connect the electrical connector(s).
If the SRS was depowered, repower the SRS. REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITH INTELLIGENT ACCESS or REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING - WITHOUT INTELLIGENT ACCESS .