Seat Cushion Cover - 60 Percent: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

From under the seat, detach the cushion cover J-clips.
From under the seat, detach the seat cover retainer.
Pull the cushion cover outboard retainer out from between the cushion frame and riser.

Fig 1: Locating Cushion Cover Retainer
Courtesy of FORD MOTOR CO.
Release the 2 cushion cover retainers from the rear of the cushion frame.
NOTE: Use care when separating the cushion cover wires from the cushion foam pad clips or the clips can be torn from the cushion foam pad.

Turn the cushion cover inside out, disengage the cushion cover wires from the cushion foam pad clips and remove the cushion foam pad.