LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Handles, Locks, Latches And Entry Systems - With Intelligent Access) >> General Procedures >> Auto-Unlock Programming >> Programming the Auto-Unlock Feature Using the Keyless Entry Keypad

Programming the Auto-Unlock Feature Using the Keyless Entry Keypad

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition in the OFF mode and close all vehicle doors.
  2. Enter the factory set 5-digit keyless entry keypad code.
  3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button. While still holding the 3/4 button, press and release the 7/8 button a second time.
  4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
scientia non olet · About LEMON Manuals