Dual Climate Controlled Seat Module (DCSM): Removal
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For component identification and locations, refer to SEAT - EXPLODED VIEW, FRONT .
-
NOTE: This step is necessary only if the DCSM is being replaced.
PMI is required when installing a new DCSM . Refer to the scan tool instructions to carry out PMI .
- Position the front passenger seat all the way back and up to access the DCSM .
- Remove the DCSM
in the following sequence.
- Remove the screws.
- Release the locking wedges on the 2 DCSM electrical connectors.
- Disconnect the electrical connectors.
- Remove the DCSM .