Special Tool(s)
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
| Bracket, Pump Remover/Installer 307-651 (Includes 307-651/1, 307-651/2, 307-651/3) |
|
| Car/Truck Engine Stand 014-01547 or equivalent |
|
| Compressor, C Clutch Return Spring 307-658 |
|
| Compressor, Clutch Spring 307-525 |
|
| Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent |
|
| Plate, C-Clutch Air 307-652 |
|
| Forcing Screw 204-594 |
|
| Gauge, Clutch Pack End Play 307-662 |
|
| Gauge, End Play 307-661 |
|
| Heavy Duty Floor Crane 300-OTC1820E or equivalent |
|
| Holding Fixture, Transmission 307-003 (T57L-500-B) |
|
| Installer, Center Support Bearing 307-655 |
|
| Installer, Front Pump Seal 307-660 |
|
| Installer, Output Shaft Seal 307-650 |
|
| Installer, Pump Seal - Non-PTO 307-657 (Includes 307-657/1, 307-657/2, 307-657/3) |
|
| Installer/Sizer, Pump Seal PTO 307-659 (Includes 307-659/1, 307-659/2, 307-659/3) |
|
| Pliers, Snap Ring 307-654 |
|
| Puller, Bearing 205-D064 (D84L-1123-A) or equivalent |
|
| Remover/Installer, Drive Pinion Oil Seal 205-440 |
|
| Remover/Installer, Rear Bearing 307-648 (Includes 307-648/1, 307-648/2, 307-648/3, 307-648/4) |
|
| Remover, Torque Converter Fluid Seal 307-309 (T94P-77001-A) |
|
| Retainer, Torque Converter 307-346 (T97T-7902-A) |
|
| Sizer, Input Shaft Teflon Seal 307-653 (Includes 307-653/1, 307-653/2, 307-653/3 and 307-653/4) |
|
| Slide Hammer 100-001 (T50T-100-A) |
|
| Socket, Output Shaft Nut 307-649 |