LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Anti-Lock Brake System (Abs) And Stability Control) >> Diagnosis And Testing >> Anti-Lock Brake System (ABS) and Stability Control >> Pinpoint Tests >> PINPOINT TEST M: The Traction Control System Cannot Be Disabled >> PINPOINT TEST M: The Traction Control System Cannot Be Disabled

PINPOINT TEST M: The Traction Control System Cannot Be Disabled

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. M1 CHECK FOR IPC DTCs 
    • Ignition ON.
    • Using a diagnostic scan tool, carry out the IPC  self-test.

    Are any DTCs present in the IPC ? 

    1. Yes  : REFER to INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES .
    2. No  : GO to M2  .
  2. M2 CHECK THE MESSAGE CENTER TRACTION CONTROL SELECTION 
    • Using the message center buttons, configure the traction control on and then off again. Refer to the Owner's Literature.

    Does the TRACTION CONTROL selection change when configured to on and off? 

    1. Yes  : GO to M3  .
    2. No  : REFER to GO TO PINPOINT TEST AD .
  3. M3 CHECK THE STABILITY-TRACTION CONTROL DISABLED INDICATOR (SLIDING CAR OFF ICON) 
    • Using the message center buttons, configure the traction control on and then off again. Refer to the Owner's Literature.

    Does the sliding car OFF icon illuminate when the traction control is turned off? 

    1. Yes  : The system is operating correctly at this time. TEST the system for normal operation.
    2. No  : REFER to GO TO PINPOINT TEST O .
scientia non olet · About LEMON Manuals