LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission - 5R110W (TORQSHIFT-R)) >> In-Vehicle Repair >> Transmission Support Insulator >> Removal

Transmission Support Insulator: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to JACKING & LIFTING .
  2. NOTE: The transmission insulator studs may come out of the insulator while removing the insulator-to-crossmember nuts. Install new transmission insulator studs if the studs come out.

    Remove the transmission support crossmember. For additional information, refer to FULL FRAME & BODY MOUNTING .

  3. Remove the transmission insulator from the extension housing.
    • Discard the bolts.
      Fig 1: Locating Transmission Insulator Bolts
      G07482236Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals