Forward Clutch Assembly: Disassembly

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Soak all friction clutch plates in transmission fluid.

Remove and discard the 2 seals and remove the No. 7 thrust washer.

Fig 1: Locating Seals And No. 7 Thrust Washer
Courtesy of FORD MOTOR CO.
Remove the No. 8 forward clutch thrust bearing.

Fig 2: Locating No. 8 Forward Clutch Thrust Bearing
Courtesy of FORD MOTOR CO.
Remove the snap ring and the forward clutch plates.

Fig 3: Locating Snap Ring And Forward Clutch Plates
Courtesy of FORD MOTOR CO.
Using the Clutch Spring Compressor Aligner and Clutch Spring Compressor, remove the snap ring.

Fig 4: Removing\Installing Snap Ring Using Clutch Spring Compressor Aligner And Clutch Spring Compressor
Courtesy of FORD MOTOR CO.
NOTE: Note the orientation of the return spring.

Remove the forward clutch balance piston and the return spring. Discard the forward clutch balance piston.

Fig 5: Locating Forward Clutch Balance Piston
Courtesy of FORD MOTOR CO.
Remove and discard the forward clutch piston.

Fig 6: Locating Forward Clutch Piston
Courtesy of FORD MOTOR CO.
Clean and inspect all components for damage.