Body Control Module (BCM) - Without Intelligent Access (IA) : Installation
WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the BCM and connect the electrical connectors.
- Install the driver side instrument panel insulator.
- Install the steering column cover trim panel.
- Download the module configuration information from the scan tool to the new BCM by following the scan tool on-screen instructions.
- NOTE: If a new module is installed, the BCM and the PCM require a parameter reset to allow the BCM and PCM to recognize each other.
Carry out the parameter reset procedure. ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS), WITHOUT INTELLIGENT ACCESS .
NOTE: If a new module is installed, the vehicle IKTs must be programmed to the new BCM .Carry out the key programming procedure. ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS), WITHOUT INTELLIGENT ACCESS .
- Train the tire pressure sensors. TIRE PRESSURE MONITORING SYSTEM (TPMS) .
- Carry out the BCM self-test (must include an on-demand self-test) and then repeat the self-test to confirm all DTCs have been cleared.