Wheel Studs: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Suspension fasteners are critical parts that affect performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Remove the wheel bearing and wheel hub. Refer to WHEEL BEARING AND WHEEL HUB - FRONT WHEEL DRIVE (FWD) or refer to WHEEL BEARING AND WHEEL HUB - ALL WHEEL DRIVE (AWD) .
Using 211-023 (AT74P-3044-A1), remove the wheel stud.

Fig 1: Removing Wheel Stud Using Tool
Courtesy of FORD MOTOR CO.