Bumper - Rear: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Left Hand (LH) side shown in illustration RH side similar.

Install the bumper.

Position the bumper to the vehicle.
Install the upper bumper nuts and lower bumper bolts.
- Tighten finger tight.
Tighten the upper bumper nuts.
- Tighten to 40 Nm (30 lb-ft).

Tighten the lower bumper bolts.

Tighten to 40 Nm (30 lb-ft).

Install the bumper cover. Refer to BUMPER COVER - REAR .