LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 240 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Glass - Rear Fixed >> Installation

Roof Opening Panel Glass - Rear Fixed: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:
  • the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
  • the roof opening panel glass has been removed from the roof opening panel system.
  • the roof opening panel assembly has been removed from the vehicle.
  • a new roof opening sliding glass or power shade motor has been installed.
  • a new roof opening panel glass has been installed.
  • a new roof opening panel assembly has been installed.

Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL  and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
  1. Install the rear fix glass panel on the roof opening panel frame assembly and install the 8 rear fixed glass panel screws.
    • Tighten to 5 Nm (44 lb-in).
  2. Install the roof opening panel frame assembly. Refer to ROOF OPENING PANEL FRAME .
  3. Check for correct alignment of the rear fixed glass panel. Refer to ROOF OPENING PANEL ALIGNMENT - REAR .
  4. Initialize the sliding glass panel motor and the power shade motor. Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL  and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
scientia non olet · About LEMON Manuals