LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 240 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Glass - Front Sliding >> Installation

Roof Opening Panel Glass - Front Sliding: Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:
  • the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
  • the roof opening panel glass has been removed from the roof opening panel system.
  • the roof opening panel assembly has been removed from the vehicle.
  • a new roof opening sliding glass or power shade motor has been installed.
  • a new roof opening panel glass has been installed.
  • a new roof opening panel assembly has been installed.

Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL  and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
  1. From the outside of the vehicle, install the front sliding glass panel assembly.
  2. Install the 4 front sliding glass panel screws.
    • Tighten to 5 Nm (44 lb-in).
  3. Check for correct alignment of the front sliding glass panel. Refer to ROOF OPENING PANEL ALIGNMENT - FRONT .
  4. Slide the concertina blind forward and clip the top portion of the concertina blind.
  5. Initialize the sliding glass panel motor and the power shade motor. Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SLIDING GLASS PANEL  and Refer to ROOF OPENING PANEL MOTOR INITIALIZATION - SHADE .
scientia non olet · About LEMON Manuals