LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical - 6.7L Diesel) >> In-Vehicle Repair >> Oil Pan - Upper >> Removal

Oil Pan - Upper: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil level indicator.
  2. Remove the flexplate. For additional information refer to FLEXPLATE .
  3. Remove the oil cooler. For additional information, refer to OIL COOLER .
  4. Remove and discard the oil filter.
  5. Disconnect the Engine Oil Temperature (EOT) sensor and Engine Oil Pressure (EOP) switch electrical connectors.
  6. Remove the nut from the oil filter header and position aside the engine wire harness.
  7. Remove the nut and position aside the transmission cooler tubes.
  8. Remove the nut and position aside the side engine wire harness.
  9. Remove the 2 nuts from the front of the engine and position the engine wire harness aside.
  10. Remove the 25 bolts and the upper oil pan.
    • Remove and discard the gasket.
    • Clean and inspect the sealing surfaces.
scientia non olet · About LEMON Manuals