LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Mechanical - 6.7L Diesel) >> General Procedures >> Camshaft Journal to Bearing Clearance

Camshaft Journal to Bearing Clearance

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the 5 camshaft bushings for wear and correct running clearance.
  2. Use a telescoping gauge and a 50-75 mm (2-3 in) micrometer to measure the camshaft bushing inside diameter with the bushings installed in the crankcase.
    Fig 1: Measuring Camshaft Bushing Inside Diameter Using Micrometer
    G08593061Courtesy of FORD MOTOR CO.
  3. To determine running clearance, subtract previous camshaft journal diameter readings from camshaft bushing inside diameter readings.
  4. If maximum allowable running clearance is exceeded, install new camshaft bushings. For additional information, refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals